Stops Rust Truck Bed Coating, 15 oz

Rust-Oleum® Auto Truck Bed Coating is designed to provide a durable, abrasion resistant, textured, non-skid finish to truck beds. It provides a barrier from rust and protects the surface from impact, scratches, weather, and fading. It reduces road noise and contours to the exact shape of the truck bed. For use on bare or primed metal truck beds. Not for use on surfaces that will come in direct contact with heat or high temperatures such as mufflers, exhaust components, etc. Rust-Oleum Truck Bed Coating features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue
caused by continuous spraying.

..PAINTING APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10-
32°C) and humidity is below 85% to ensure proper drying. Avoid spraying in very windy and dusty conditions. Cover
surrounding area to protect from spray mist.

SURFACE PREPARATION

Bare Metal or Sound Rust Surfaces: Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to
thoroughly dry. Remove loose paint and rust with a wire brush or 120-220 grit sandpaper. Remove all sanding dust
with a clean cloth. Protect and mask off all surrounding areas to prevent overspray. For best results, spot prime
bare or rusted surfaces.

Previously Painted Surfaces: Thoroughly clean the area with a commercial detergent, or other suitable cleaning
method. Rinse with fresh water and allow to thoroughly dry. Note: Cleaning is recommended before and after wire
brushing or sanding. Use a wire brush to remove any loose or peeling paint. Sand the surface with 120-220 grit
sandpaper. The use of 249321 Primer Sealer or any of the sandable primers (249419 Red, 252472Light Gray, or
249415 Gray) will enhance corrosion resistance and improve hiding.

APPLICATION
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-12″ from surface and spray in a
steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Remove
any overspray from the auto finish immediately. For best results, apply 2 coats, allowing 1-2 minutes between coats.
Do not use near open flame.
DRY & RECOAT
Dry time and recoat times are based on 70°F and 50% relative humidity. Allow more time at cooler temperatures.
The surface can be recoated within 1 hour or after 24 hours. Allow 72 hours for full cure before placing objects in
the truck bed.
CLEAN-UP
Wipe off tip when finished. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.